NS-01

Pongee Non-slip

This is a non-slip material with a polyester base.

※If ordering by roll, please enter 100 in the quantity field.

〈Handling Precautions for the Non-Slip Series〉
The dot portion of the non-slip series is designed with resin selected first and foremost for its non-slip performance. For this reason, the main component is a relatively soft resin. As a result, it also has certain limitations in use, as described below.
Please note the following items to maximize the non-slip performance and maintain it over the long term.

1) Properties in relation to heat (tumble drying, ironing, heat pressing)
To ensure non-slip performance even in low-temperature environments, the main component is a temperature-sensitive resin.
Therefore, at high temperatures the dots may soften, causing deformation, detachment, or transfer.
For example, heat from tumble drying or ironing applies here.
For washing and drying, avoid forced heat drying such as tumblers, and air drying in the shade is recommended.
Ironing and heat pressing involve not only heat but also pressure, so these are the most important to avoid.

2) Properties in relation to plasticizers, waxes, and oils
Plasticizers contained in PVC sheets, sofas, and similar products, as well as waxes and oils used on flooring, furniture, and similar items, may soften the dots and cause transfer, detachment, or deformation. Please avoid direct contact for long periods.

3) Properties in relation to solvents (kerosene, thinner, etc.)
The resin in the dots may dissolve or swell in certain solvents. For example, if kerosene, thinner, or other solvents are spilled, do not rub immediately; soak them up with a cloth or similar material and remove them. Also, avoid using solvents when removing stains.

4) Dry cleaning
Likewise, please avoid dry cleaning.

5) Washing
Hand washing in lukewarm water is recommended. If using a washing machine, place the item in a mesh bag and wash on a gentle cycle. For composite products such as those with outer fabric, strong friction and other loads may cause the dots to come off, so please hand wash in lukewarm water.

6) Strong friction or excessive load
If heavy furniture or similar items are placed on the material, the dots may be crushed. Also, dragging or other friction may cause the dots to partially slip off or deform. Please avoid these actions.

7) Contact with glossy surfaces such as varnished or lacquered finishes
Please avoid placing it on glossy surfaces such as pianos. Marks from the dots may remain on the glossy surface.

8) Blocking phenomenon
As noted at the beginning, because the dots use a relatively soft resin, it cannot be said that there is no possibility of adhesion to the material in contact, in combination with the issues above. Please check periodically for any abnormalities.

9) Properties in relation to sunlight
The dots are relatively resistant to sunlight, but avoiding direct sunlight is not a problem. Doing so will allow longer use.